820-2936b no power no green light

2informaticos

Administrator
Staff member
Test first disconnecting webcam.
If still low, try known good trackpad board/flex.

Check if R5260/61 are good.
Also test removing R5222/23.
 
Last edited:

tipoti

Member
* webcam no connection
* i tried with different trackpad board/flex it works same "fan full very slow"
* i removed r5222/23 but still same "fan full very slow"

ASD runing
* ERROR 1 ( Unable to read sensor) Test Failed
Temperature ( Ts0P) palm test #1
 

2informaticos

Administrator
Staff member
Do you get only one error in ASD?
Run it in Continue mode.
That error is still related with trackpad (Palm Rest temp sensor).
 

tipoti

Member
* ERROR 1 ( Unable to read sensor) Test Failed
Temperature ( Ts0P) palm test #1
* ERROR 9 motor unable to stabilize between min and max limit
* Error 7 Fan motor is spinning slower than it should
* Error 1 Fan motor is stalled
 

2informaticos

Administrator
Staff member
Change the motor; see if other errors disappear.
Try another trackpad flex/board.
Inspect trackpad connector pins.
 

tipoti

Member
* i tried with 3 diffrent trackpad but same
* i check it trackpad connector lines no problem
* i also changed motor
 

2informaticos

Administrator
Staff member
Motor errors still present after changed it?

Check R5270/71.
Post diode mode to ground on their SCL/SDA lines.
 

tipoti

Member
* check it R5270/70 1K
* R5270 PİN2 / SDA = 0,532
* R5271 PİN2 / SCL = 0,562
* I changed the motor, same result.
 

2informaticos

Administrator
Staff member
Looks like big diference on that bus; compare readings with similar board.

So you still get motor related errors after changed the motor?
 

tipoti

Member
yes same error
yes same error

asd is very slow working , takes 1 hour

different cards have different values, what should i understand from this ?

Diode mode

820-3115b = J5800 PİN 19 = 0,708 PIN 17 =0,609

820-2936B = J5800 PIN 19 = 0,561 PIN 17 = 0,532
 

Attachments

  • error1.jpeg
    error1.jpeg
    613.2 KB · Views: 5
  • error2.jpeg
    error2.jpeg
    956.9 KB · Views: 5

2informaticos

Administrator
Staff member
Yeah, the first error is about right fin stack proximity (Th1H), not palm rest.
Pay atention when you read the ASD messages!
Check Q/U5520 areas.

Your machine has only one fan, I don't understand how do you get messages about two fans.
In fact, left fan is reported as OK.

I suppose you didn't use proper ASD version.
Try ASD EFI 3S144.
 
Top