Search results

When battery is plugged in it will go up to 2.50amps before dropping to 0.02 when low battery icon appears on the screen

Yes, all ports have same behavior. They all go up to 0.40amp before dropping to 0.02amp

Would a 140w charger make a difference in this case?

Already using a brand new original 96 watt charger

This arrived with no power. When plugged in you get the low battery symbol but nothing else. No liquid damage. PPBUS_G3H is 12.80V. PPDCIN_G3H is not shorted. Read on another post battery is not required for this board. When battery is disconnected the board only goes up to 0.20amps and drops...

Yes, several different ones.

Yes I will measure again but should be fine since C7020 was replaced along with the isl9239 what should be checked next??

Does it seem fixable?? Sounds like hopeless project since CPU and GPU can’t be replaced on these. Is there any chance it could be their power ICs or something else in the circuit??

R7061/62 reading anywhere from 1.6-2ohm C7020 21.5 ohm red probe C7020 black probe ground ohm modes R7060 and traces to U7000 are fine. When the board first boots with battery and charger connected (after both have been disconnected) it appears to be charging fine, however once charger is...

This issue just randomly started for the customer. They claim it happens while they are using YouTube or even conferencing. Board is clean with no burn spots or liquid damage. See attached picture for crash details. Any ideas what could cause this?

replaced Q7065 Q7040/30 and C7020-C7023 but no change

no 21.5ohm

R7061/62 1.6ohm

This arrived with no liquid damage. Issue is when charger is plugged in it will act as though its being plugged in and out every few seconds. PPBUS_G3H voltage with charger and battery 11.15V. 11.50v with battery alone. 12.65v with charger alone but only low battery symbol appears on the...

https://northridgefix.com/product/voltage-injection-tool-short-circuit-finder/ Would this work ok for pure shorts?

https://store.rossmanngroup.com/dc-power-supply-multimeter-banana-plug-to-alligator-clips-cable.html Cables currently being used

Yes, cables are tiny and amps are set at 5 on lab PSU. What size cables do you recommend? Using same bench PSU as Rossmann

This arrived for liquid damage repair on 10/2020 and just recently came back for no power. PPBUS_G3H is shorted. Resistance to ground 0.06. Checked all big coils but none of them have the same resistance to ground. Injected 1v into PPBUS_G3H drawing .900amps but nothing is getting warm. Since...

When injecting 3v nothing got warm. Can this low value be the issue even though 3.3v is present? What should be removed first?

Can you advise on what to check or try next? Have a good board besides this one and all components are present. The only diode measurement that is off is PP3V3_G3H_RTC good board is around .350 but only 0.085 on this board but cannot be a short since 3.3V is still present